Vehicle & Technical > Discovery

snorkel - Airbox

<< < (2/3) > >>

Jake:
A Viper induction kit looks like this

Basiclly, its a performance filter in a housing which is great for putting in the snorkel intake line.
A through cab snorkel is basiclly a normal raised air intake but instead of going up the A piller, it passes through the cab and then up the rear of a truck cab vehicle like this

This the best solution on challenge trucks as it puts the snorkel / filter around the back out of harms way.
You can just simply fit a filter on the top of your snorkel, just be careful in trees  :wink:

I hope this had made it more clear for you and maybe given you some ideas

 :cool:

Pablo011:
Hi jake that Filter in the last pic looks like one you can get from any motor factor place, is it ok to be used outside of the car I mean , waterproof and say weather proof
because if so I could connect the snorkel end that fit through the wing to the turbo/engine air intake and the top of the snorkel fit one of those filters couldn't I ??



thanks

Paul

Pablo011:
And if it can be used on the outside as per the pic then that would be great and an easy way to fit my snorkel thingy

Paul

Jake:
If you've got a good quality filter like a Greens or K&N then its OK you just need to clean it regularly.
To assist in the protection of mine, i fitted a Outerwears micro cotton pre-filter which catches a lot of the junk and allows for decent airflow into the filter. (you can can see the green cover on my filter)
They're not expensive, about £12 each.

 :cool:

Pablo011:
So a K & N filter like in the pic would be ok on top of my Safari snorkel then, and I would't lose any engine performance would I ????

thanks

Paul

Navigation

[0] Message Index

[#] Next page

[*] Previous page