Vehicle & Technical > Range Rover

4spd zf box

(1/3) > >>

jasonforsythe:
hi just fitted a zf to an isuzu lump and with the engine running there is no drive now not sure if the transfer bos is engaging or not but no life from the gear box ,now i have just filled with atf does it take a while to get running or do i need to connect the electrics on the box?

thank you jason

vougese39:
the zf box if it is from a disco2 or p38a is not compatable with the earlier cars as it has a electronic control. also the box will be valved for the v8 not a diesel so it will be valved wrong i would have stuck with a manual.
possible fault with box is the torque convertor not installed properly and you have crushed the oil pump box fubar

jasonforsythe:
that sounds bais it a quick fix or a new convertor as i bolted the box to engine a loud clunk came from the bell houseing then it closed up fine any ideas ?

trecfive:

--- Quote from: vougese39 on May 25, 2010, 22:10:23 ---
possible fault with box is the torque converter not installed properly and you have crushed the oil pump box fubar

--- End quote ---

The loud clunk was the drive dog on the oil pump breaking,another box required or someone to change the pump.

jasonforsythe:
great more stuff to do so i guess its the box out again any choice torque convertor suppliers spring to mind ,do you think the box will be ok?

Navigation

[0] Message Index

[#] Next page