Vehicle & Technical > Discovery

Chequer Plating

<< < (4/5) > >>

stuntman:
Lee I can only say that was more by luck than planing, I just used the straight edge for the top section so it was a nice finish, it seems to have worked out ok though  :twisted:

This is my top console mark 1, I'll be trimming the top and adding a thick rubber door seal to contour to the roof and finish it off. I just needed somewhere less likely to get soaked as I'm planning major wading in the distant future, last time it came over the bonnet the cb got soaked when the water came up to the gearstick  :D







I know there is a gap at the top but I'll trim the panel down and edge it with thick black door seal rubber to contour to the roof.

And yes I'm having a push button start :)

mentalmoshio sophs V8i:
vvvv nice m8 that giving me ideas all ready  :-k :dance: :dance:

Disco_Stu:
I would not like to crack my head on that stuntman, make sure you keep your distance from the car in front mate  :shock:

stuntman:
I have the benefit of long legs! So I'm quite far away it, and yes I have smashed my head on the Bl**dy thing.

And let me tell you it does hurt.

I have thought of adding a soft 'bump' strip as edging on the leading edge.

mentalmoshio sophs V8i:
time to update ur avater me thinks  :-k its looking so much better now :D

Navigation

[0] Message Index

[#] Next page

[*] Previous page