Vehicle & Technical > Discovery
cam belt whats the worst
eugene:
thanks for the advice get down to it saturday any let you know the outcome.if it bad can get hold of
a second hand head if needed
Dr Neil:
personally i wouldn't remove the cylinder head! As has been said remove the rocker shaft and pushrods,chances are some will be bent.Replace the bent pushrods(after checking the rockers) and replace the timing belt/tensioners and then start the engine.
99% of the time that's all you'll need to do [-o<
good luck
Neil....
eugene:
well started today took rocker cover off and released cam no cracked rockers and took pushrod out only one with slight bend init the one at the back got crank bolt out and pully off loosend all bolt tha needed to come out good start for the morning. when i tryed cranking over no rockers moved so hoping it is belt not snapped crank as somone mention to me today fingers crossed 8-[
davidlandy:
snapped crank! wow, somehow I think that may be unlikely
eugene:
hope so he said in all years he been mendins landys he has only ever know it to happen twice
and they were both discos snapped end off hope it aint that
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version