Vehicle & Technical > Range Rover

RRC EAS ECU RESETTING

<< < (2/4) > >>

petergalileo:
Noticed you are in Essex, give this lot a call tlm landrovers 01255 830 331, they are in Tendring in North Essex.

Range Rover Blues:
If you can get the pump to run then you will have some air in the tank, then you can open the valves to let that air into the airbags.  Disconnect the ECU under the driver's seat and connect the the wiring plug with fly leads.

Ok, I've never done this myself as I own Rovacom, but it is possible.

DAVE39V8:

--- Quote from: "Range Rover Blues" ---If you can get the pump to run then you will have some air in the tank, then you can open the valves to let that air into the airbags.  Disconnect the ECU under the driver's seat and connect the the wiring plug with fly leads.

Ok, I've never done this myself as I own Rovacom, but it is possible.
--- End quote ---


How and what wires do I use to connect to the ECU plug..
Also where is the pump and valves..
As you can see i'm not familiar with all this..  :lol:  :lol:

Range Rover Blues:
Ok the pump and vlave block are in a box under the car, below your bum :wink:

Thought he pump sounds like it's in the back right?

The ECU is under your seat and if you disconnect the plug to it I understand you can jump acrross the pins to run the pump and open the valves you need, though I havn't done it myself.

You would need the wiring diagram.

Alternatively on flea-bay there are manual inflation kits sold for P38, so you can use a tyre inflator to directly infalte each corner.  These kits will also fit the classic, they cost around £70 though :o

Range Rover Blues:
astoakes@tesco.net , if you get stuck

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version