Vehicle & Technical > Range Rover
RRC EAS ECU RESETTING
DAVE39V8:
Can anyone point me in the right direction of getting my EAS ECU reset.
The N/S front bag exploded while playing in the muddy stuff Sunday.
Managed to get it 3miles from home driving on front bump stops when the rear dropped too making a mess of the rear N/S tyre.
I have changed the damaged bag,reconnected the ECU and switch under drivers seat..but the EAS up and down switches are both illuminated and it not pumping up..
I have been told this is due to the ECU going in safe mode?????
Anyway i'm in the essex area if anyone can help. :(
Thanks in advance.
Dave
Skibum346:
Any decent garage should have a rovacom or some such that can read the fault log and reset it. Wouldn't imagine it'd be much more than £50 as long as that's all they're doing.
I'd stay away from Land rover Stealerships... aside from the way they'll look down their noses at you... they also charge an arm and a leg!
Have you got a local 4x4 specialist...?
DAVE39V8:
I'm not sure if there any 4x4 specialists in my area will have to search around..
They won't need to have the car aswell as the ECU will they only it's not drivable...????
Range Rover Blues:
Let me get this right, it was fine before the bag burst and now, having repaired the bag, it's locked in safe mode.
Before you drive it anywhere check that it's still got it's bump stops.
If all that needs doing is the faults clearing then technically it could be swaped to another car and the faults cleared on that one, or you could fit a second hand ECU to yours and then take it to be recallibrated.
But generally the ECU needs to be in the car.
Unfortunately unplugging the ECU won't clear the faults.
But you can unplug the ECU and manually run the pump with a jump wire, then open the inlet valve and each corner valve to get it off the floor.
Does the pump run at all?
DAVE39V8:
It were ok before sunday(although it had started to lean alittle beforehand on the corner mentioned when left for afew hours).But that were due to the faulty bag.I hope..
No the pump doesn't work now..
Where are the valves located etc..If I can raise it manually at least I can use...or can I????? :)
Navigation
[0] Message Index
[#] Next page
Go to full version