Chat & Social > The Bar - General Chat

I need help ;-)

<< < (7/10) > >>

Porny:
My TD5 is still 'in the build' process....


--- Quote --- It will be fine
--- End quote ---
...  :roll:

Matt, what do you think the effects of a high compression ratio (i.e. you skim too much of the head) would be???  



Ian

mud-club-matty:
if the head has not been skimed and it dont look like it has because when a head is skimed the edges are sharp but the head he has gont the eadges are not sharp so it might not of been skimed the only way to solve it it take both heads off

Porny:

--- Quote from: "mud-club-matty" ---if the head has not been skimed and it dont look like it has because when a head is skimed the edges are sharp but the head he has gont the eadges are not sharp so it might not of been skimed the only way to solve it it take both heads off
--- End quote ---


Depends if it's properly finished.....

I know of some one who used to sell recon engines....  They were freshly painted, so must have been rebuilt.

Not.  All he did was repaint them, never stripped them down or rebuilt them.


Ian

mud-club-matty:
yer true so whats they way to do it then

Porny:
Properly...

Take both heads off, and meaure the volumes of the head and the cylinder/piston.

Do the calcs and compare the two results.





Ian

Navigation

[0] Message Index

[#] Next page

[*] Previous page