Vehicle & Technical > Discovery

ABS diagnostic socket location

<< < (3/3)

Matbrown:
Couldn't get the blink test to work using the OBD plug.  :(
Light just stayed on permanently.



Mat.

Range Rover Blues:
If you have removed the sensor from the knuckle then chances are the retianing clip is bust and you will need a new one, the sensor very quickly moves too far away and will eventually give you another fault reading as if it were totally failed.

As a rule I leave the senor in the pin when stripping the swivel to avoid this problem.  The clip should always be renewed when the sensor is disturbed apparently.

Matbrown:
I haven't messed with any of the sensors yet, not been able to get the ABS light to blink to find out what the fault is.


Mat.

Range Rover Blues:
If you find a sensor out of position then light will go out next time you drive it.

Matbrown:
Got it sorted in the end, took it down Trinity Land Rover and hooked it up to the T4, there were 6 faults stored, once we had cleared those the light has behaved itself (Fingers crossed).

Thanks all.


Mat.

Navigation

[0] Message Index

[*] Previous page