Vehicle & Technical > Range Rover
rangie lift
p4203:
not removed self leveller yet thatds next job took it off road last weekend to see what was wrong . need to cut the arches back a bit as they were digging into the tyres which are 31x10.5x15 grizzly claws :D as for welding no time yet to busy working and playing in the snow :P
paul_humphreys:
Heres mine with a OME 2 inch lift. The tyres are 235.85.16 grizzlys.
bullfrog:
The levelr pulls the car back down after a lift, so yes just unbolt it. You may want to cut the 2 top bolts as they wont go past the x-member. You could just put the buts back on. I plugged the holes to stop water.
The ball joint should have a clip or if seized cut just on the shaft.
Leave the A-frame as t locates the axle ! :)
p4203:
hi bullfrog as my shed is still slightly down after fitting the springs do you think it is possible thet the self-leveller is seized and holding it down?
bullfrog:
I would doubt its seized just pulling the old girl back down !
It will do your head in so bin it anyway.
No use on lifted vehicle !
I reckon when you have some cash it needs a 2" block kit , maybe some bent arms ! :D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version