Vehicle & Technical > Discovery
to grind or not to grind?
davidlandy:
try grinding a groove into it then putting a nice sharp chisel into it - then get a BIG hammer to persuade it off. Some heat would also probably be helpful.
Landy90IOM:
hmm... brings back memories!
as davidlandy said would work, but my way would be better... more heat, and a bigger hammer!
landyman Ash:
Got the very same job to do this weekend!
Lots of heat, grind a groove into each side and use a dam good puller
Failing that, go with David and cur a groove, big chisel, even bigger hammer
Oh, and whatever you do, use some goggles! When they go, thay can send bits all over the place :shock:
Damonski:
and if none of the above work, get an even bigger hammer 8)
landyman Ash:
--- Quote from: "Damo" ---and if none of the above work, get an even bigger hammer 8)
--- End quote ---
A man after my own heart!!!!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version