Pages: [1]   Go Down

AuthorTopic: CAV injector pump.  (Read 967 times)

0 Members and 1 Guest are viewing this topic.

Offline MTyrrell

  • Posts: 366
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
CAV injector pump.
« on: May 29, 2005, 21:44:26 »
Just a quick question about injector pumps.

 One of our ford tractor has a CAV injector pump and a "Pull to stop" cable arrangement, when you stop the engine using the cable it stops fine but the stop cable wont go back in, it is sticking at the injector pump. I have disconnected the cable to make sure it wasn't snagging somewhere so it looks as if it a problem inside the pump.
 
 Dose this mean that the injector pump is goosed or is there a way of repairing it cheaply
Logged
Regards
Matthew

www.cbpsystems.co.uk/(updated: quite often)
"Growing old is mandatory, growing up is optional"
<p>
In the dark it is better to be lead by a blind man! So in this age of insanity is it better to be lead by a mad man?

Offline beast5680

  • Regional Rep
  • *
  • Posts: 2938
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
    • hailsham east sussex
  • Referrals: 0
CAV injector pump.
« Reply #1 on: May 29, 2005, 22:59:28 »
if i remember you can undo the two nuts on the top and remove it and there is a spring/lever arrangement inside(long time since i had one apart) if its had water through it it seizes these up just enough to stop them returning correctly
when you put it back on make sure everything is in the right place or it wont stop :shock: as the stop lever misses its contact
Logged
Neal

let him that hath understanding reckon the number of the beast

He, who laughs last, laughs best. He who laughs at Chuck Norris dies.
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal