Vehicle & Technical > Defender

30min job, yea right says the wife!

<< < (2/3) > >>

EvilEd:

--- Quote from: "davidlandy" ---if you got a new one then smash the old one off with a hammer

 :twisted:
oh, undo the pipe first :wink:
--- End quote ---


Is that smash the landy off the slave cylinder and keep the slave :)

Oops... I'm out numbered by Landies here  :P

Ollie:
Gonna go with Dave's execellent advice, tomorrow's the day, I'll let yer all know [-o<

Ollie

Xtremeteam:
dont how ever unclip the pivit pin from the clutch arm as its a pain to clip back in unless u do what i did & cut a 3 inch hole in the bellhousing(well it was on christmas day & it was snowing n i was doin it outside)

unknownmanxman:
I did this when it came to change my slave cylinder.... and i found a good way was to just use DOT 3 instead of DOT4 brake fluid.... its thicker and doesnt leak out!! its cheaper aswell!!!
It worked for me

muddyweb:

--- Quote from: "Ollie" ---Gonna go with Dave's execellent advice, tomorrow's the day, I'll let yer all know [-o<
--- End quote ---


I hope you aren't seriously thinking of hitting the slave cylinder with a hammer  :shock:

It is bolted into a cast Aluminium bell housing !!!

Navigation

[0] Message Index

[#] Next page

[*] Previous page