Vehicle & Technical > Range Rover

Back of rear brake lights....

(1/2) > >>

JumboBeef:
I want to fit a high level brake light to my 1991 RRC.......but do you think I can get into the back of the rear brake lights to access the wiring?  :x

How do I get in please?

Thanks!

Rainbird:
When I added mine, I didn't go to the back of the light unit.  You can pull the trim back on the c pillar to find the wiring and connect to that.  You only need the 12v supply to the brake lights as any earth will do the job

JumboBeef:
Thanks, but I can't see how to get behind the trim...........?

Rainbird:
I have to admit that I can't remember exactly what I did, but I do vaguely recall taking the spare wheel out.  I think I dropped the wire down behind the c-pillar trim after pulling the head lining down a bit and then it was accesible at the bottom

Next time I'm in the boot I'll take a look and remember what I did - it was about 10 years ago now!

jjsaul:
The wiring runs along the edge of the roof on each side behind the headlining, you can tap into it from there :-)

Navigation

[0] Message Index

[#] Next page