Chat & Social > The Bar - General Chat
9 finger glove
carbore:
I thought sillicone sealer (like your bathroom stuff) was the way to go? (not so stikcy is permenent)
paul_humphreys:
--- Quote from: V8MoneyPit on December 01, 2009, 17:17:05 ---Just found this.
A bit pricy though.
--- End quote ---
The problem with those ones is if you get wd40 on them they just dissolve!!
Paul
Oz:
well thank you i have oreded one from him. so we shall see how it goes... hopefully wont need to put wd-40 on it now proberly pack it with grease :)
Thank you very much
auf_wiedersehen_pet:
--- Quote from: V8MoneyPit on December 01, 2009, 13:13:31 ---I also used motorcycle chain grease, available in aerosol cans, sprayed over the cap and the ends of the leads. Never had any trouble ever again.
--- End quote ---
I did that - works really well until you come to swap the leads - what a sticky mess!!
:oops: :oops: :oops: :oops:
burgerman:
I think i may be a tad late in replying :( I had a rubberised cap on my V8 disco, Worst thing i ever fitted, all it did was condensated up inside and caused a bigger misfire than before :lol:, As stated above, good quality leads, caps ect, and 2 breathers from the bottom of the dizzy housing. and yes a good lasing of antiwater spray type solution, worked a treat for me :dance:
Wd40 will disintegrate the blue covers turning them into sticky mush
sorry to sound negative, just my experiences ;)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version