Vehicle & Technical > Series Land Rovers

Removing an overdrive

<< < (2/2)

bogie:
The bits you need mate are the gear,nut,washer and blankin plate . You can retreave these from any 2 or 3 box. If you get stuck ive got plenty sittin here.

Disco Matt:
Thanks - don't you also need the bearing and bearing sleeve?

I think he's hoping to get somewhere with the seller, but obviously just in case the seller becomes evasive and difficult he needs an alternate solution and this looks the simplest. Taking the seat box out and bolting the bits back in will be much less hassle than fitting a new gearbox.

Lucy1978:
The bearing and sleeve are held in the blanking plate at the rear of the box by the circlip, so would most likely come with any 2nd hand one you bought.

clodhopper:
hello mat, i have the flange c/w bearing, the gear and the nut that you need. i'm near welshpool, if i'm not too far from you and you can collect you can have them. give me a call 07989 479093, gareth

Navigation

[0] Message Index

[*] Previous page