Vehicle & Technical > Defender
Rear axle swap
kizz81:
cheers,
ill do the A-frame bushes and joint,
i have just replaced the trailing arm bushes with super pro ones so im not going to change them
cheers kieran
Tiki Al:
Just about to do this myself :)
have the axle, just waiting on a new ball joint and bushes :)
burgerman:
Just done this job last weekend, Apart from 1 bolt not coming out of the axle, it all went fine, if we wouldnt of had the bolt "issue" then i reckon about four hours from start to finish
300TDi Disco:
I done this conversion a while back now and the difference in breaking was better but i need to get a new master cylinder. Brake pedal sinks when I'm in traffic.
No major problems when fitting, I had to undo the drivers side radius arm with a spanner as the rachet wouldn't fit. It did take me abit of time to do, but i do recon i could do one alot quicker now i know what to expect.
kizz81:
how annoying!! i have the axle sat on the garage floor along with all the bits to fit,but i have ran out of time so it'll have to wait untill next weekend :roll: :evil:
Navigation
[0] Message Index
[*] Previous page
Go to full version