Vehicle & Technical > Discovery

CB and In cab winch switchs Places?

<< < (2/3) > >>

landymadjay:
Cheers for the pic .


Where did you route it to get it to the centre console bit inside?

clbarclay:
The winch switch was fitted a while after that last photo was taken, but you would bearly see the wires from that angle anyway.

I used 3 core flex, IIRC the cores were 1.5mm2. It runs out of the solenoid box the other side to the main power cables, along the wing and through and existing hole in the bulkhead. From their it runs inside the dash across to the side of the transmisson tunnel, along under transmission tunnel trim to behind the window switch pannel.

GreedyGibson:
My CB is mounted to the back of the centre console on top of the rear tray facing up. it just about sits level with the top. its a moonraker maplins jobby. I used my redundent rear wiper and washer switches for my winch on my 200TDi you can take them apart and i have written in/out on each switch and they illuminate :). can get some pics if you are interested

Budgie:
As I only had a 3 door (no rear electric windows) I used the spare blanks for the winch controls.
I wired a spare electric window switch for IN & OUT and had the live feed to the switch running through an master power switch so that the controls couldn't be operated accidentally from inside the vehicle.
The power is cut off to the controls as soon as you touch the red cover as it springs closed, turning the switch to the OFF position at the same time.  ;)

lee celtic:
I made a metal box (sheet steel bent on the side of the bench) to fit the CB to the middle of the dash along with a slide mount so it comes out quick when not needed the rubber mat goes through two slots in the sides after it's been fixed down ..Also added some drink holders while I was at it... :cool:

Navigation

[0] Message Index

[#] Next page

[*] Previous page