Vehicle & Technical > Discovery
Heater blower cutting out
carracarra13:
what would you charge to fit it m8 lol hang on think I no this answer half a pig lol
boss:
well. i got to do some welding for you anyway so shall we say for the welding blower motor fitting petrol and evereything £30 with a sandwege? :D
hobbit:
If you can get up under the drivers footwell, you will find the connector from the controls to the wiring leading to the motor, my probslem was terminal as it just didn't work one day, turned out that the earth had packed up somewhere in the system
If you have already checked the feeds out from the switch to the motor try connecting a fresh earth from a good source to the earth wire on this lead back to the motor, I think its the black one, but check with the wiring diagram before trying
Another thing to do if you have a sticking motor is to again locate the feed wires under the drivers footwell, helps if you are a limbo dancer though :lol: , and put a 12v feed onto the wiring plug, after unplugging it from the switch loom, see if you get any action, if not try reversing the polarity of the connections, it will run in reverse, sometimes it can un sieze a stuck motor, it needs a decent size cable to try this and be careful not to burn anything, if the cables you are holding get warm, stop, and try pulsing the connections rather than a continious burst of power
Banjo:
When I turn my blower off the wipers come on, do one sweep of the screen then go off again. :lol:
hobbit:
--- Quote from: Banjo on February 11, 2009, 08:53:08 ---When I turn my blower off the wipers come on, do one sweep of the screen then go off again. :lol:
--- End quote ---
Welcome to the little quirks of land rover ownership :lol:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version