Chat & Social > The Bar - General Chat

Number plate

<< < (2/2)

Saffy:
Post 2001 top and side margins = 11mm
Pre 2001 top and sides margins = 13mm (group1) 11mm (group2)  (definition of groups?)


It's got the sizes of the margins here (most of the reg plate sellers got this detail and its on the DLVA site somewhere too :

http://www.plates4less.co.uk/FAQ/FAQ-New-AboutREG3.asp

Mines shortened to fit winch cover, passes MOT but that doesn't mean it's legal really, but I think it is.

hairyasswelder:

--- Quote from: JumboBeef on January 14, 2009, 15:49:15 ---I *think* the law is only really tight on post-2001 motors, so if you are before this, I wouldn't worry.

My 1991 Defender has a six digit reg and I cut down the front plate to fit a winch bumper more than four years ago, and so far, no problems!

(this is an old photo from about 2005).

--- End quote ---
That is exactly what I am planning  ;)


--- Quote from: Saffy on January 14, 2009, 16:27:30 ---Post 2001 top and side margins = 11mm
Pre 2001 top and sides margins = 13mm (group1) 11mm (group2)  (definition of groups?)




It's got the sizes of the margins here (most of the reg plate sellers got this detail and its on the DLVA site somewhere too :

http://www.plates4less.co.uk/FAQ/FAQ-New-AboutREG3.asp

Mines shortened to fit winch cover, passes MOT but that doesn't mean it's legal really, but I think it is.


--- End quote ---

Perfect  ;) when I searched I found a private plate FORUM  :roll: :roll:

Job is now ready to go.......  :D

Thanks

Steve

Navigation

[0] Message Index

[*] Previous page