Vehicle & Technical > Discovery

Any one breaking a Disco 200tdi (early model)

<< < (4/5) > >>

Mud-muncher1:
I think its more like someone tightened it up and the connector has got stuck and twisted the pipe or it was not seated properly,
well that my 2pence worth


Jav

dan3411:

--- Quote ---not being funny but it looks like you have got your slave cylinder in upside down it mite be why that pipe did not fit
--- End quote ---

No it is the right way up... bleed nipple at the top. I took the pick from the top of the engine bay

dan3411:
This is not even funny anymore.. anyway the situation is at the moment is.

There IS a difference between the 200 and the 300 and even potentially the early 200 and the later 200's



Top one is 300 bottom one is off a 200 (note different threads)

The bottom one appears to be the correct one :) (the one that solihull-mick sent me)

But unfortunately the thread is [!Expletive Deleted!].

So i am after the slave cylinder pipe off an early 200tdi disco.   [-o<

Any help is much appreciated

ibruceuk:
Have you got an old one?

Just chop the ends off and re-use them on a new bit of pipe....

dan3411:

--- Quote from: ibruceuk on December 22, 2008, 19:37:04 ---Have you got an old one?

Just chop the ends off and re-use them on a new bit of pipe....

--- End quote ---

That the whole reason i need a new pipe the ends are cracked!

Mark Soulsbury found the part on rimmerbros..  so all is good at the  moment. untill i cometo fitting it and someting else is broken...

Navigation

[0] Message Index

[#] Next page

[*] Previous page