Vehicle & Technical > Discovery
Any one breaking a Disco 200tdi (early model)
dan3411:
--- Quote from: solihull-mick on December 18, 2008, 17:50:16 ---Posted you one this morning mate,
--- End quote ---
Just came now. I owe you one buddy :dance:
dan3411:
:doh: It's about 1.5 cm too short! no ammount of bending would make it reach.
will give fruitloop a call and see if his one will fit.
If not though what sort of place could i get some piping at 6 mm diamiter and 3.5mm bore?
Already asked around local dealers.. even went to the hydraulics place to no avail.
Mud-muncher1:
Just been looking at mine and i'm pretty sure that the bleed nipple is supposed to sit flush with slave cylinder with no threads showing, has yours always been like that?
Jav
dan3411:
Yea the original was the same... could it be because it is 1990 model?
Nick4X4:
--- Quote from: dan3411 on December 17, 2008, 15:56:37 ---
--- End quote ---
not being funny but it looks like you have got your slave cylinder in upside down it mite be why that pipe did not fit
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version