AuthorTopic: changing the pistons  (Read 483 times)

0 Members and 1 Guest are viewing this topic.

Offline trickydicky

  • Posts: 193
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • took some bits off now its streemline
  • Referrals: 0
changing the pistons
« on: December 07, 2008, 19:49:27 »
wile changing the head i noticed i have 2 cracked pistons can anybody tell me the efects of this and can i change them whithout removing the engine? are there any pitfalls i kneed to know?

Offline craig_midz

  • Posts: 397
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: changing the pistons
« Reply #1 on: December 07, 2008, 20:31:56 »
if its a 19j engine its a common thing cracked pistons u can change pistons while engine is in but u will have to remove sump an the head an cracked pistons will cause low compression so poor power an poor startin

Offline Les Henson

  • Posts: 369
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Is it supposed to do that?
  • Referrals: 0
Re: changing the pistons
« Reply #2 on: December 09, 2008, 02:12:37 »
Cracked pistons are usually caused by heat stress, which is common on the TD engines. You drain the oil and remove the sump, then remove the big end cap nuts and push the piston/conrod assembly up the bore. Piston kits are approximately £40 each and come with rings already fitted, piston pin, and circlips. Big end caps are matched to their respective conrods, so make sure you keep them in order.


Les.

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal