AuthorTopic: 200tdi engine into a 300tdi disco ?!?!?!?!?  (Read 928 times)

0 Members and 1 Guest are viewing this topic.

Offline Papa Smee

  • Posts: 55
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
200tdi engine into a 300tdi disco ?!?!?!?!?
« on: October 10, 2008, 12:43:07 »
Hi all.......... I'm considering changing the 300tdi engine in my disco for a 200tdi engine.

Basically, I've had enough of doing the head gasket every 5000 miles on my 300 disco  :sad:  :angry:  :cry:

It's come to the point where it's a new head as this one can't be skimmed again, and I have an old RRC here (rotten as a carrot!!) that has a good 200tdi in it.

My question is this - how simple is it to change?

Will the 200 go onto my R380 gearbox, or will I have to find an LT77? (Gearbox in rangey is - well - knackered  :lol: )

Exhaust not a problem - I have the RRC one, and I'm sure I can get that done.

Do I need different engine mounts, etc?

Any advice would be appreciated - I'm sure someone's done it before.
'96 'P' Red Disco 300 Tdi - Papa Smee - aka Graham.
Stock suspension, Pirelli S/T Tyres, custom Stainless Steel steering & Diff guards, RRC front bumper, RRC Bull-Bar, front roof lights.

'96 'N' - Dark Green Disco 300 Tdi - Sqn Ldr, RRH - aka Big Ben.
2" H/D Suspension lift, 2" Body Lift, TJM T17 Winch Bumper, 16000lb winch, Airtec 3" bore Snorkel, 235.85/16 Saharas (rear), 235.85/16 c-trax (front). Custom roof-rack with roller, yellow (yes yellow...) Weller 8-spoke steels, custom yellow 6mm steel chequer-plate steering guard.

'90 'G' Disco 200 V8 3dr - The Beast - Stock at the mo.... new pick-up off-roader project - watch this space......


Offline Budgie

  • Regional Rep
  • *
  • Posts: 2217
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • This post is best viewed on a computer.
    • Lochaber
  • Referrals: 0
Re: 200tdi engine into a 300tdi disco ?!?!?!?!?
« Reply #1 on: October 10, 2008, 13:16:22 »
I don't know about the engine mounts but the bellhousing is different on the 300 to the 200 but whether you can get away with just changing the bellhousings over or whether you will need to swap the whole gearbox, I not sure.

Offline andyb

  • Posts: 412
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
    • Tilshead, Wiltshire
  • Referrals: 0
Re: 200tdi engine into a 300tdi disco ?!?!?!?!?
« Reply #2 on: October 10, 2008, 15:45:22 »
I don't know about the engine mounts but the bellhousing is different on the 300 to the 200
On Defenders yes, but in RR and Disco both boxs fit the 300 TDi so logically a 200 will go on an R380. No idea on engine mounts. Tape measure will tell you. :)

Offline crazymac

  • Posts: 1891
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: 200tdi engine into a 300tdi disco ?!?!?!?!?
« Reply #3 on: October 10, 2008, 16:37:23 »
No idea about engine mounts but I have an R380 mated to my 200 with no problems :dance:
I HAVE THE BODY OF A GOD

shame its Budda!!

Offline stuntman

  • Posts: 693
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: 200tdi engine into a 300tdi disco ?!?!?!?!?
« Reply #4 on: October 11, 2008, 07:28:50 »
Engine mounts will need to be chopped off and rewelded back on. But go for it mate, you can't beat the good old tractor 200
1989 3.5slti Mazda powered 110DC

Erm ... I've lost my keys darling ... again!

Offline way2deep

  • Posts: 850
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: 200tdi engine into a 300tdi disco ?!?!?!?!?
« Reply #5 on: October 14, 2008, 23:23:32 »
just done a 300 out and 200 in on my mate's disco.bell housing, clutch and slave cylinder all ok
...problems we encountered were
engine mounts ,use the 200 ones
used the 200 rad and intercooler (rad pipes in wrong place)
200 power steering pipes (300 end would not fit 200 power steering pump)
 fuel pipes to lift pump and fuel filter(different ends causing air to get into system) didnt notice this fault till we test drove it and was suffering from fuel starvation
200 exhaust system all the way thru
200 alternator cos belt drive different
200 airbox
disreguard extra wires going to fuel pump,there's a block of 3 (i think wires that are no longer used)

any further info ya need i will be only too glad to help if poss ...ask on here or phone me .
robbie 07912184192
p.s. he was suffering with the head troubles too and is happy he made the decision to go for a 200 fitment  :D
« Last Edit: October 14, 2008, 23:28:16 by way2deep »
robbie
200 tdi rangie  1989  4dr

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal