Vehicle & Technical > Discovery

new sills and xmember

<< < (2/2)

hobbit:
You can buy pre fabbed units, paddocks did have some, although I think the supply is drying up on them, worth a look round though

As said rear (body?) crossmember patching is preferable over replacement, fitting and lining up the rotation onto the verticals is a swine, I did one and we removed one from a donor vehicle, easy to actually weld sod to get into the right position

Skibum346:
This guy seems to have plenty available...

http://shop.ebay.co.uk/merchant/bubble_factory

hobbit:

--- Quote from: Skibum346 on September 24, 2008, 16:01:50 ---This guy seems to have plenty available...

http://shop.ebay.co.uk/merchant/bubble_factory

--- End quote ---

Typical, I found that after I had struggled to do mine, same as the rear floor panels, as in the side pieces not the main floor pan

Mine looks like a patchwork quilt :lol:

chiboy:
 :shocked: Doing this one at the moment  :shocked:

Navigation

[0] Message Index

[*] Previous page