AuthorTopic: Y wont it rev?  (Read 5111 times)

0 Members and 1 Guest are viewing this topic.

Offline johnniep

  • Posts: 209
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Y wont it rev?
« on: February 20, 2005, 21:46:12 »
ive got a 3.5 efi auto and when changeing gear it wont rev beyond 3500 and then when in top gear it wont rev past 3000 revs, = 50mph,
getting a bit anoying now, just been recently serviced, leads,plugs etc,still wont rev, any ideas?
cheers
j.p :twisted:
rangie1, nissan 3.5tdi 4door vogue
rangie2, perkins 6cylinder 5.5litre disel 2door
rangie3, 3.5 v8 4door bobtail
rangie4, 2door engineless, probs b a special!

Offline nzrover

  • Posts: 176
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Y wont it rev?
« Reply #1 on: February 22, 2005, 10:12:26 »
I assume you've checked all the obvious bits like fuel pressure, ignition timing, mechanical advance, vacuum advance, blocked air intake, blocked exhaust (crushed, cats fallen apart, muffler disintegrated internally), that it actually get full throttle when you press the accelerator, etc, etc

Offline johnniep

  • Posts: 209
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Y wont it rev?
« Reply #2 on: February 22, 2005, 19:52:05 »
yeah i only recently serviced it, and i cut the exaust off th the manifold to see iif it was blocked but still wouldnt rev right out, not sure wats wrong with it,im thinking it could be the ecu possibly, dont know,umm bloody british technology!!

j.p :twisted:
rangie1, nissan 3.5tdi 4door vogue
rangie2, perkins 6cylinder 5.5litre disel 2door
rangie3, 3.5 v8 4door bobtail
rangie4, 2door engineless, probs b a special!

Offline Grunter

  • Posts: 42
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Y wont it rev?
« Reply #3 on: February 24, 2005, 23:08:33 »
just a thought, you say you have recently serviced it, did you use the same oil or a different one, might be pumping up the tappets early, a mix of a different oil of just 10% can cause the oil to sludge with micro baterial growth which would take a few days to set in, was it this sort of time that it stopped revving properly? might be worth a check before looking at the more expensive stuff...
This should present no significant problems

83 4dr R/R
LPG, Chrysler auto, 265's
Steering guard
2" suspension lift
2 1/2" body lift
es9000 +4"

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal