Pages: [1]   Go Down

AuthorTopic: outriggers  (Read 391 times)

0 Members and 1 Guest are viewing this topic.

Offline andyhubbard

  • Posts: 788
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
outriggers
« on: March 21, 2008, 07:43:55 »
Are they the same on 200 and 300 Discos-only asking regards fitting a set of quick fit sidesteps,cheers Andy.
Logged

Offline stuntman

  • Posts: 693
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: outriggers
« Reply #1 on: March 21, 2008, 10:33:18 »
Hello Andy,

They should be mate, as the body shells swap over very easily. And the bolt on rock sliders fit 200 and 300 series motors.

What you fitting now anyway!  :P
Logged
1989 3.5slti Mazda powered 110DC

Erm ... I've lost my keys darling ... again!

Offline Range Rover Blues

  • Moderator
  • ***
  • Posts: 15218
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +3/-0
    • South Yorkshire
  • Referrals: 0
Re: outriggers
« Reply #2 on: March 22, 2008, 04:02:57 »
Very similar chassis, the outriggers you need are the same on either model, the chassis changes are the rear axle crossmember, the exhaust and fuel tank brackets, holes for the EAS, engine(TDi) and ARB mounts, the body mounts were unafacted AFAIK.
Logged
Blue,  1988  Range Rover 3.5 EFi with plenty of toys bolted on
Chuggaboom, 1995 Range Rover Classic
1995 Range Rover Classic Vogue LSE with 5 big sticks of Blackpool rock under the bonnet.
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal