Vehicle & Technical > Discovery
2inch spring fitted but dont look right
windowlicker:
--- Quote from: clbarclay on February 28, 2008, 21:37:06 ---I should think you have them on the right way round*, its just the rear springss you have selected are too long and stiff compare to the front springs to give a balanced ride height. Easiest solution is to do like a friend and just put a large oil cooled welder in the back, which will weight it down nicely.
--- End quote ---
well i have three kids and another on the way so if i then have another to fill the last spare seat the truck should sit fine lmao
windowlicker:
i had a quick measure up against a standard one and from the centre of the hub to the line on the body its 45mm higher on the front and 115mm higher on the back and thats with all the interior back in but without spare fitted.
so i took the rollbar off to see if that was stoping it settling as it was at a funny angle but it made no difference to ride hight so theres must be something wrong somewhere
clbarclay:
--- Quote from: windowlicker on February 28, 2008, 21:43:47 ---you are the spring king [-o<
--- End quote ---
Just because I occasionally sit on a throne it doesn't make me royalty.
The measurement I was meaning was the length of the spring its self when compressed, measured from the top to bottom spring seats.
windowlicker:
:lol: where ever did you find that pic
im going to do a bit on the car later so will get them measurements its just im shocked that +2's have given me +4
windowlicker:
heres one i took the other night after fitting the springs sorry about the crap pics its just its always dark as ive been doing it after work
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version