Vehicle & Technical > Discovery
Cooling Water leak.... continued......
BigA:
Received the K seal today, got home and thought i best check water level correctly and ensure no airlock whilst i am at it, following so many top ups recently. Went to remove the filler plug from above the thermostat housing, gave it a little twist to test with screw driver, top of the poxy thing came away :x looks as though water been getting out of there for a while now too, by the deposits around the tiny bit that was still attached....
Now need to find one of them, managed to bodge it for now, lets face it, if any water is leaking around the bold i have just screwed into the remains of the filler plug, the k seal should block it :D
Andy
davidlandy:
got one of those here in kettering - foc if u want to fetch it
BigA:
--- Quote from: davidlandy on February 25, 2008, 20:34:37 ---got one of those here in kettering - foc if u want to fetch it
--- End quote ---
Cheers mate, i will PM you.
Frankie-Boy:
I bought brass replacement ones for mine Andy, one for the radiator and the other for the thermostat housing, they are both the same thread and better than the plastic ones, after they both fell apart.
BigA:
--- Quote from: Frankie-Boy on February 26, 2008, 04:52:00 ---
I bought brass replacement ones for mine
--- End quote ---
Where did you get them Frank?
Cheers
Andy
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version