Vehicle & Technical > Discovery

What should i do?

<< < (2/4) > >>

muddymart:
After an hour or so i finally got the carpet out and the nice thick soundproofing,
The floor doesnt seem too bad only a couple of holes where the screwdriver eventually went through,

I suppose if i compensated doing the suspension myself, i might as well get the floor done as well, time i started learning !!!

Mr Alford:

--- Quote from: "muddymart" ---After removing the bumper i noticed  the rear body x member had rotted all way through, and at least a 1/4 of each sill had rotten too,
The rest of the disco seems pretty solid, and has been faultless for nearly a year.

Should i A, get it all welded up with nice new bits

or B: Throw the money i would spend above and p/x for a 5 door,
though   i dont mind the three door, and im eager to get some mods done,

PPPPPPPPPlease help, i'm sure a couple of you have been in this situation before
--- End quote ---


cut the old one off weld ona  new one for not much more and half as much hassle ull never regret it

Tyke:
Muddy . . . . Al is doing a lot of welding work through Ray at 4X41 up past Grangemoor roundabout on the Huddersfield road . . . . give him a call and he'll put you on to him. Let him know the RiffRaff lads put you on to him and he should sort you  :wink:

stuntman:
I chopped my floor out and was still driving around in mine, just doing a little at a time, the best thing you can do is buy the new panels and cut the old out and prep the area for welding, that should cut down on welding costs if your paying someone else to help you

Range Rover Blues:
Well it's worth nowt as it is, so spend the money, get it fixed and keep it, safe inthe knowledge that it's reliable rather than buy another car that someone else it sick of.

Navigation

[0] Message Index

[#] Next page

[*] Previous page