Vehicle & Technical > Discovery

stereo fitment

<< < (2/3) > >>

denviks:
try undoing the 2 front screws holding the center consul down.... then fit stereo and then do up the screws again gentley  :wink:   worked for me

Chris Putt:
What mr Denviks said.

Also, there is a piece of soundproofing directly under the back of it- cut it out CAREFULLY with a stanley knife that gives you and extra few mil, I found my foot helped too.


Chris

chris9119:
patience, patience, patience......

Connect up the ariel and other cabeling and put radio into hole.

Gently pull ariel cable and speaker cables from behind dash......., using long, thin screw driver, push cables to the side as you gentle press home the stereo...... An  :idea:  is to spray the cable sheath with lubricating liquid to make them slide through the bulkhead hole.....

Jobs a gooden......., mine always fits correctly  :D

chiboy:
8) Had same prob on range rover classic .Take a long socket ex and a big hammer and make a small dent under the radio were the airel sits jobs a good un 8)

treeman:
cheers lolil give some of those ideas a go in the week, thinkin of the arial wire i dont think the jack plugs for my amp are helping, il give em a go but i think il resort to the hammer technique if i have a day like today lol cheers guys :-)

Navigation

[0] Message Index

[#] Next page

[*] Previous page