Vehicle & Technical > Defender

Cubby box fitting ???

<< < (2/2)

marjan:

--- Quote from: "Andy 300tdi" ---i drilled through the cubby box and plate then attached the nut's from underneath.

only way i could figure it out :roll:  :roll:
--- End quote ---


Yep, that's what I have ended up doing too, seems strong enough.

By the way, I may know you as I used to live on Towngate.

Andy 300tdi:

--- Quote from: "marjan" ---
--- Quote from: "Andy 300tdi" ---i drilled through the cubby box and plate then attached the nut's from underneath.

only way i could figure it out :roll:  :roll:
--- End quote ---


Yep, that's what I have ended up doing too, seems strong enough.

By the way, I may know you as I used to live on Towngate.
--- End quote ---


quite possible Iwas born on what used to be Chapel st, behind the old co-op and raised on Teall st

V8MoneyPit:
I used some of the plastic captive nuts used for the floor sections in the plate. Just had to drill, then file out to square to fit them. Then used the same screws as the floors through the base of the cubby box. They are dirt cheap, even from a main stealer!

Bush Tucker Man:

--- Quote from: "marjan" ---By the way, I may know you as I used to live on Towngate.
--- End quote ---


Digressing, one of out Nurses has just bought a house off Towngate

Navigation

[0] Message Index

[*] Previous page