Vehicle & Technical > Defender

Cubby box fitting ???

(1/2) > >>

marjan:
Advice please on how to mount a cubby box in a Defender 90. Only way I can see is to mount it to the plate between the seats and the screw the plate back in place, is this possible?

Andy 300tdi:
i drilled through the cubby box and plate then attached the nut's from underneath.

only way i could figure it out :roll:  :roll:

richo:
Iv'e got the one from scorpion racing and it came with a mounting bar with theaded bar welded to it .It was just a case of drilling holes and getting under the 110 and doing the bolts up .Took me about 1-2 hours.

Xtremeteam:
2 tech screws through bottom o the cubby box into the allly plat underneath, no crawling about fafing about with bolts n washers & needing some1 else to help you

took me about 15 min

Bush Tucker Man:
My old 90V8-CSW actually had threaded inserts in the centre cover-plate :shock:

But, both 110's have had to be drilled & the boxes bolted on

Navigation

[0] Message Index

[#] Next page