Vehicle & Technical > Discovery

Pulling out a bull bar... !?

<< < (2/3) > >>

Sharpshooter:
Smash the drivers head against it repeatedly, until all traces of the dent are gone.  :twisted:  :twisted:  :twisted:  :twisted:

clodhopper:

--- Quote from: "Sharpshooter" ---Smash the drivers head against it repeatedly, until all traces of the dent are gone.  :twisted:  :twisted:  :twisted:  :twisted:
--- End quote ---


i wish i thought of that when the low life in a merc van hit me :(bigangry):

Ja1983:
get a piece of solid timber, that will fit behind, rope this to a tree/solid obect so it pulls straight..

get someone COMPETANT (most SWMBO will not be!) :twisted: to watch carefully, as it will spring back a bit once load is removed..

position you vehicle carefully to consider where the "pivot" in the pull will be, ie, where the tubees are bent.. probably at the abar part.

good luck!

Sharpshooter:

--- Quote from: "clodhopper" ---
--- Quote from: "Sharpshooter" ---Smash the drivers head against it repeatedly, until all traces of the dent are gone.  :twisted:  :twisted:  :twisted:  :twisted:
--- End quote ---


i wish i thought of that when the low life in a merc van hit me :(bigangry):
--- End quote ---


It worked for me when someone knocked my mirror off, whilst overtaking me. Thats how close he was.  :evil:

tomkbucks:
if someone hit you - just get them to replace it thats what insurance is for ! nice new bar for you ,

Navigation

[0] Message Index

[#] Next page

[*] Previous page