Vehicle & Technical > Defender

Snorkel

<< < (2/3) > >>

extreme90:
its a plastic bend
ive got the bend here if you want it  ??
you will need to get the proper outter wing skin tho so its in the exact spot it needs be, or else it wont fit
ill get a picture up of it tomorrow for you so you can see, unless i find one tonight :wink:

but offers there matey, pay for postage its yours, altho i say say take a pipe direct or turbo, or to the air box as there isnt any joins then
dan

Ridgeback:
Thanks Dan,

I have sent you a PM. If i could have that bit of pipe it would get me one stage closer to sorting the problem.

I do also agree with you that less joins is better but i will be using lots of water tight gasket paste and good strong hoses.

I want to be able to use a standard air filter.

Matt

zulublue:
Matt,

you can still use the standard air filter you just do away with the wing attachment part.

extreme90:

--- Quote from: "zulublue" ---Matt,

you can still use the standard air filter you just do away with the wing attachment part.
--- End quote ---


yep thats what i was going to say, id rather you do that than use this join i have  :?  i dont like them one bit

your far better off using a pipe direct onto the airbox than using the wing intake IMO

dan

Ridgeback:
so if I go the direct to air box way, I need to drill a hole in the top of the wing. I do see your point about the wing fitted version.

I just dont want it to look like a lash up job.  

I think paddocks do a kit that goes in through the wing top, just looks like it will hit the heater box.

Navigation

[0] Message Index

[#] Next page

[*] Previous page