Will Discovery standard steel rims fit on a Series 2a?

[Spacemud]

:?:

[jjsaul]

should do because the PCD is the same!

[TechnoTurkey]

Yes they will, but SWB only as LWB may exceed their load rating.

[Jim-Willy]

Have them on my S111 88" but the studs are a bit short.

[ChrisV8]

:lol: Check the stud size I think Series 2A has small studs so wheel hole may be rather large. Recently there was a report in LRM the garage man Mike Manifold of a Series losing a wheel writing the LR off and the car it hit !!!! Basically the small studs are not large enough to hold the larger wheel, that was using Wolf wheels I think and their centres are even thicker than a Disco's.

[Bob Ajob]

:lol: Check the stud size I think Series 2A has small studs so wheel hole may be rather large. Recently there was a report in LRM the garage man Mike Manifold of a Series losing a wheel writing the LR off and the car it hit !!!! Basically the small studs are not large enough to hold the larger wheel, that was using Wolf wheels I think and their centres are even thicker than a Disco's.

The studs are wider as of Chassis suffix H.

Regarding longer wheel studs, see this thread:
Wheel studs

Do you know anyone nearby with a disco on steels that you can try?

[Spacemud]

Thanks chaps. Was looking at some wheels on ebay, but think I will stick with standard steels for now. I just stripped and painted the standard steel silver and it's looking good now.....................plus it's cheaper  

[Devon-Rover]

I have disco steels and have no problem with the wheel studs. They are a wee bit short and it is just shy of a full nuts worth but they are done up well and so shouldn't move.

[Little-Green-Machine]

i have the same question bout' chrome modulars cos if disco wheels fit and they are made for the same car :roll:

[barny]

My sig pic shows the same set off wheels being used on my 300tdi, and my '58 series 2. At the time it had the original  shorter studs which have now been replaced with the longer series 3 type.

There is a thread i've posted on here on how we changed them over to s3 ones.

HTH,

b  :D

[Spacemud]

Completely off subjet now, but 'Devon Rover', where did you get the rock sliders for your Series?

[Spacemud]

Completely off subjet now, but 'Devon Rover', where did you get the rock sliders for your Series?

[Spacemud]

How did that happen?  :?

[Devon-Rover]

I made them myself.

2 inch by 1 1/2 box IIRC.

Will measure them up to be sure.

[Niel]

I made them myself.

2 inch by 1 1/2 box IIRC.

Will measure them up to be sure.

Any pic's of them pre fitting, looking at diy for my csw

[Little-Green-Machine]

cheers for the info bout the modulars mines a rebuilt 2a with a lot of series 3 parts so it may have series 3 hubs and studs :D