Vehicle & Technical > Discovery
Discovery Exhaurst !!!!
peasey:
mate i have seen this done im sure by a fella on here looked so good i was going to have a go myself but lacked the bottle required let me know how you get on mate as im really interested in how to do it!p.s. pukka picture at the bottom of your post!!!
katenrob:
I,m going to have a good look this weekend at what pipe work will be needed plus angles also try and find some sort of trim for the hole. May take me sometime to do it but it will be worth it.
Glad you like the photo , it was taken on the old coach road near keswick cumbria
Range Rover Blues:
I missed on on Flea aby that had no solencers at all and no cat. The seller said it sounded louder than standard :shock:
No kidding
Lyndsey731:
Scorpion Racing do the the stainless steel trim.
Good luck
Gav
ian101:
Got this done on mine a couple of months ago, but I have not noticed any real difference in noise without the backbox (but idid not do it to create more noise).
I bought anew and supposedly hand made end piece from an exaust maker in Rochdale but this was clearly not the right size and so had to be butchered to fit, my advice would be to seek the skills of a skilled fabricator (landy mechanic) and get it knocked up from old exhaust, the very end is just a piece of stainless with a roll top.
Snip the hole in the rear panel with some snips and then fasten a Devon 4x4 exhaust ring on.
I have my boost valve turned up and I think these engines 'over fuel' by design so it does get smokey when I put my foot down in 2nd, but if you're aware of this you just accelerate gently (or smoke out the twit in the comvertable)
Will try and post some pics later, but I would say get it done....Plus it improves the departure angle when off-road, so its win-win.
Regards
Ian
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version