Vehicle & Technical > Defender

Rusted drive flange prob

<< < (2/3) > >>

extreme90:
a grove cant dissapear  :lol: ..if you no what i mean, its there some where and thatll be your problem  :wink:
there will be two washers (shims) and then your circlip, so where ever the washer end is where the circlip goes, clean the grove out and then you can remove the flange

dan

Hangover:

--- Quote from: "TheBlueySilverThing" ---a grove cant dissapear  :lol: ..if you no what i mean, its there some where and thatll be your problem  :wink:
there will be two washers (shims) and then your circlip, so where ever the washer end is where the circlip goes, clean the grove out and then you can remove the flange

dan
--- End quote ---



Believe me Dan this groove has gone,i had to prize the rubber hub caps off and what was underneath looked like something off the Titanic.

extreme90:
is it a good un then  :lol:
seriously tho, its there, clean it up good, you need that groove showing before the flange will come off or else your wasting your time as the splines on the flange wont pass over it

dan

Hangover:
This pic should show how bad it is but i think i can save it.

extreme90:
rust's holding that in, can see abit of the groove but not much, but even so, the flange is solid, you tried whacking it with a copper hammer yet ?
dan

Navigation

[0] Message Index

[#] Next page

[*] Previous page