AuthorTopic: Rear Hinges  (Read 969 times)

0 Members and 1 Guest are viewing this topic.

Offline lyndon

  • Posts: 151
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Rear Hinges
« on: April 20, 2007, 16:47:20 »
My rear door has dropped ever so slightly. Is there any adjustment or is it new hinges?.

Offline barmiebrumie

  • Posts: 1745
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
    • Birmingham, M6 J7
  • Referrals: 0
Rear Hinges
« Reply #1 on: April 20, 2007, 18:28:25 »
New hinges, have seen some people drill them out & put pins/bolts & washers in but not very sucessfully, news ones are about £35 each,
John.

Offline ids

  • Posts: 5
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Rear Hinges
« Reply #2 on: April 20, 2007, 21:13:46 »
My local dealer supplied the hinges as used on a Disco II - much better design and did the trick.  You may be able to get away with doing the top hinge first....

Offline lyndon

  • Posts: 151
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Rear Hinges
« Reply #3 on: April 21, 2007, 09:38:55 »
So I take it theres no adjustment then ?

Offline redhand

  • Posts: 936
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Rear Hinges
« Reply #4 on: April 21, 2007, 09:43:56 »
Quote from: "lyndon"
So I take it theres no adjustment then ?


Not on the rear door but there is on the front ones, a series of shims allow you to adjust them You could try putting washers behind the bottom hinge only as that will lift the door upwards but I haven't tried it so it would be a case of try it and see.
http://www.humber-yorks4x4response.org.uk/
www.landyzone.co.uk
www.landrovernet.com
www.mig-welding.co.uk

1987 TD90 Hard Top

I haven't got a clue where I'm going. But God Help Them when I get there..

Offline bilge rat

  • Posts: 726
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Rear Hinges
« Reply #5 on: April 21, 2007, 10:03:29 »
there is minor adjustment, on the door and the hinge where it locates to the rear 1/4. i drilled and replaced the pin , good job but will also get a later hinge iff i have to re do it. cheers alan.....

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal