Vehicle & Technical > Range Rover

ABS light

(1/4) > >>

Merlin:
On a 90 RRC 3.9efiA is there any way I can put the ABS light out.  All the brakes work fine but the light comes & goes as it pleases so is there a fuse or anything that will put it out permanantly.

Range Rover Blues:
No.  If it's coming on then there is a fault somewhere, maybe one that's clearing again I don't know.

If it doesn't come on at startup then it's an MOT fail.

Pm me if you need any help with it.

I have a car I'm doing up to sell, some claud had connected the dash warning lamp to the ignition lamp so as to fool the MOT tester, never mind that the brakes didn't work :shock:

buster uk:
my abs and traction control light comes on when i go over 60mph but once its turned off and restarted it goes.
Its bugging the hell out of me  :cry:

Merlin:
Serviced the front brakes this weekend, hubs off, inner bearings serviced as well but the light still comes on intermittently.
When it warms upn a bit (work outside & bl--dy cold up here now) I will fit new discs to the rear but have been told the ABS rings are hard to get off.  MOT a week Tues. so still time to solve the problem.
It only started to come on after some seriously muddy off-roading so am hoping sh-t is the problem.
Any tips on getting the rings off in one piece?, I don't have heat.
Merlin

Difflock:
Check that you have no crap bridging the ABS counter rings on ALL 4,I had a Honda accord once that had an intermitent ABS problem,turned out to be some cassette tape had wrapped around the sensor ring and the sensor its self couldnt count the gaps or if they are the magnetic sensor type make sure it isn't choked with iron fillings

Navigation

[0] Message Index

[#] Next page