Vehicle & Technical > Discovery

Ball Joints ???

<< < (2/3) > >>

freeagent:
and good luck getting it all appart if they have been in there for a while... :roll:

Range Rover Blues:
Absolutley, I spent an hour with a blowtorch and hammer, plus a can of WD40 failing to get one of mine free.  Best advice is to loosen one at a time and remove one balljoint, then grip that balljoint and try to turn the thing round, take it out not screw it in.

hairyasswelder:
I used a vice and a big pair of stilsons,  plenty of wd and wire brush on grinder, blowtorch on standby  :lol:

Doesnt matter if you trash the old ones  :wink:

If you clean them first you can see which one is the lefty, then still 'undo' it the wrong way   :roll:

Steve

Range Rover Blues:
Mine are so tight the stilsons weren't having it, that's why I smacked it with a hammer.

hairyasswelder:

--- Quote from: "Range Rover Blues" ---Mine are so tight the stilsons weren't having it, that's why I smacked it with a hammer.
--- End quote ---


You need to see the stilsons  :twisted:  :twisted:
4 ft long and huge jaws

Steve

Navigation

[0] Message Index

[#] Next page

[*] Previous page