Vehicle & Technical > Series Land Rovers

Mill Services Rock Sliders

<< < (2/3) > >>

rustprooflandyracer:
I used the same bolts, they are long enough, might have a problems with the bulkhead dropping down slightly so use a highlift ot keep it all lined up ready for bolting back together!

jjsaul:

--- Quote from: "rustprooflandyracer" ---I used the same bolts, they are long enough, might have a problems with the bulkhead dropping down slightly so use a highlift ot keep it all lined up ready for bolting back together!
--- End quote ---


or get a spare tube/ bolt of the same diameter and drift one out with the other so there is always something holding the bulkhead up. thats how we fitted the mill services sliders to our 110

fire boy si:
dude pm me with your email and i'll send them to you. i have the instuctions and diagrams on disk

Mike1975:
Hi, I'm still being a complete muppet with these.  Can anyone send me some pics of the rear brackets you've made because I keep going to get these fitted and end up staring at the things thinking [Edited]!

heeeeeeeeeeeeeeeeeelp :)

MattMatt:
Looked at this last night.  Rather than use the instructions on the website (which I found really strange) how about getting some 2" angle iron, weld/tack/bolt it to the rear tang on the Rocksliders so it links up to the underside of the rear tank support on the chassis.  Then you can bolt it to the same holes the tank uses (weld it there if you want).  Bolting it on means it's easily removed.  I'm going to get some angle iron today so I'll try and get some pics done.

Navigation

[0] Message Index

[#] Next page

[*] Previous page