Vehicle & Technical > Series Land Rovers

Mill Services Rock Sliders

<< < (3/3)

Mike1975:
It's the website instructions I'm having problems with as well.  I thought if I could actually see a picture I'd be able to work something out.

MattMatt:
Ok this is what I’ve mocked up.  It needs welding and painting yet so no comments about the look.

1 x 400mm length of angle iron bolted to the underside of the outrigger.  That will be welded (bolted at mo) with bracing for strength to the rear tang on the Rockslider.

I had to grind down the tube at the front so it would all line up.

What do you think?

Mike1975:
that look good and at last i can see how they may fit!  will pull the landy out the garage tomorrow and compare what you've done there :)

ty

Navigation

[0] Message Index

[*] Previous page