Vehicle & Technical > Suzuki

Lifting an SJ410

<< < (2/3) > >>

redneck:
Replace your Tbox mounts with LR 90/Defender engine mounts part number ANR1808. I got them from www.paddockspares.com Tel. 01629-760877, IIRC about £2.60 each inc. v.a.t., but exc. postage.  
, they need a bit of trimming to fit but are a good mod, i've also used them for my engine mounts as well.  :wink:

muddymesser:

--- Quote from: "generation-x" --- buy the whole SPOA kit from say rob @ rubbers it comes with the Zbar already made.
why not just fit lifted springs from SMJ in leeds 3" lifted springs will set you back under £300

simon
--- End quote ---


my dad lifted his to get 35" on n it cost around £90

generation-x:

--- Quote from: "muddymesser" ---
--- Quote from: "generation-x" --- buy the whole SPOA kit from say rob @ rubbers it comes with the Zbar already made.
why not just fit lifted springs from SMJ in leeds 3" lifted springs will set you back under £300

simon
--- End quote ---


my dad lifted his to get 35" on n it cost around £90
--- End quote ---

ok messer let us all into the secret then?

simon

muddymesser:
swap rear leafs off rascle n th 1s tht cam wit ur sj chop th ends off n stick em in th front

over axel converson

make ur own shackles

11" over standard brake lines (bfg)

home made steering linkage . . . cut th original in half n put a spacer in

shocks moddified by an engineer . . . ok weld a bolt to th top to extend them

and have a friend tht gives u some 35" bfg mt's

muddymesser:
from standard to this in £90

Navigation

[0] Message Index

[#] Next page

[*] Previous page