Vehicle & Technical > Series Land Rovers
Series 3 Bulkhead
danielh89:
sorry still not got round to doing a pic of my screen mounts i went a simular rout to mark by bolting them on.
mine were chopped off the old one a pice of plate welded in the back that was drilled and taped.
i will do my best for a pic
reriessandlover:
was there any need to do anything with the bulkhead feet, i have one a 90 bulkhead to fit to my 3 but the feet dont line up with the outriggers
mark.yellow.series.3:
bulkhead should go straight on :?
how far out is it?
reriessandlover:
its not that far out about 5 mm ,the bolt covers half the hole ,but its knowing which way to go more than anything else, i could do with finding out the distances between the mounting holes on the chassis and the bulkhead ,and also it has had new outriggers so one of them could be out but which one, would appreciate it if someone has measurements from inside the chassis rail to edge of outriggers on both sides to eliminate the odd one :? :(
mark.yellow.series.3:
measurments shmeasurments :lol:
get some longer bolts and a big hammer,m thats how mine fitted.
after market out riggers wont be exactly the right size so a little adjusting will be in order.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version