Vehicle & Technical > Series Land Rovers

Series 3 Bulkhead

<< < (5/9) > >>

danielh89:
well if i dont do it now i will forget to do it  :lol:

you will need to modify the tunnle i did this by siply welding the one off the series bulkhead on i think you have to beat the footwells out a bit so they line up with the new tunnle.





you also have to modify the divers footwell for the stearing to claer i did this by chopping the corner off and weling it back in inside out. the other thing in the drivers footell is the exelorator pedal/ linkcage now i have a 10j and so have a defender pedal fitted with a cable to opperate it.







dash fits straight in i think you need some fixings along the top at the back of the bottem pice of dash but thats the easyest bit of the job :lol:



i havent got any pics of my windscreen mounts so i will sort you some next week.

you will need to chop the windscreen wiper mount and bolt the series motor straight to the bulkhead. the heater will need some mounting holes in the footwell as there are non.
there are a few big holes in a defender bulkhead that arnt used its up to tou weather or not to weld or put rubber bngs in :wink:

i think thats all of it but if you need to know more i will try and help.

Dan

Tinks:
Looks like you done an awesome job there mate! :D

Pix of windscreen mounts would be ideal! :wink:

Thans very much for all your help!! 8)

Mike1975:
http://forums.lr4x4.com/index.php?showtopic=11692

These guys are talking about a chap that makes brand new ones for series 2 to original specs, might do 3's as well

mark.yellow.series.3:
i just fabricated some bolt on ones

Tinks:
They look good to me, nice n simple.

Thanks for the help guys! :D

Navigation

[0] Message Index

[#] Next page

[*] Previous page