Vehicle & Technical > Range Rover

P38 Range Rover EAS Problems

<< < (3/5) > >>

Jason2985:
Valve blocks can be expensive, again get them on Ebay second hand.
But you are taking a chance like everything else S/Hand really.

Jay

waveydavey:

--- Quote from: "ben_haynes" ---i have done air leak checks on all joints with a bit of WD40,
--- End quote ---


Why did you use WD40? Anyhting oil based will perish any rubber. Soapy water is best, possibly still a good idea to wash off the WD40.

I had something similar and it stopped lifting when i was away from home. I stripped the compressor - a dead eeasy job, put vaseline on all the seals and O'rings and it hasn't had a problem since.

Worth a go for the cost of a bit of Vasaline? Incidentally KY or silicone jelly may be better for the same reason as above but I had to use what I could find at the time.

ben_haynes:
used it as it was first thing to hand and it got washed off this afternoon as it rained today  :lol:

Range Rover Blues:

--- Quote from: "Jason2985" ---
There maybe some one on here that has a testbook (Rovacom).

Jay
--- End quote ---


Me.

Tell me, when you satart the engfine, all 3 switches should light up, yes?

Then after about 5 seconds they all go out, or do 2 of them stay on?

Will it go into high profile, the up button flashes whilst it's rising then stays on constantly plus the dashboard light (if fitted) lights up.

Does it go into access, push the down button, with the car in park.  Again it flashes whilst moving then on constantly.

If tyhere is a door open it will do nothing at all, all day long.

Check the dissable switch under the back Off side of the driver's seat, a bitch to find it's roughly level with the front edge of the carpet and may be in backwards.  It should be centred, if it's down the EAS is dissabled.

ben_haynes:
must be different on the classic to the P38 as it dont have 3 switches it only has one up/down switch with a row of 4 lights showing the height and it does not have a dissable switch under the driver seat but there is an inhibiter switch next to the lights for the height?

so this is no help to me but cheers for trying RRB

Navigation

[0] Message Index

[#] Next page

[*] Previous page