Vehicle & Technical > Discovery

Rock slider design

<< < (2/2)

nishikigoi:
So your welding to the old inner face? Will this be strong enough (if it's not too rotten). My sills are OK but a need a bit of attention, I have tree bars ready to weld onto sliders so thought it was much better to mix the 2 together.

Smego:
I saw a post on I think diff-lock that shown low profile design for sliders/relpacement sills...?  have a search if I find it I will bung up a link.

I have just gor some Gardian ones that are still lock up in the shed if you every down Farnhan way, you are welcombe to get your tape measure out...?

nishikigoi:

--- Quote from: "Smego" ---I saw a post on I think diff-lock that shown low profile design for sliders/relpacement sills...?  have a search if I find it I will bung up a link.
--- End quote ---


Cool if they have got some info  8)

clbarclay:
My sills (or at least the off side at this moment) are made from 100*50*3 box section and I chopped out all of the old sill because the top and outside were rotted through and i expect the bottom and inside needed it too. Sections of 3mm plate were used to make the chassis mount brackets.

Not a quick job :cry:, but is very satisfying to have a solid sill and floor :D .


My next plan is to use a length of tube as a rock/tree slider and brace it to the box section.

boss:
go look at disco parts rock sliders. i got them on mine and there bomb proof!

Navigation

[0] Message Index

[*] Previous page