Vehicle & Technical > Mitsubishi

jacking up a delica

<< < (3/3)

joker777:
measure from the hub centre to a vertical point on the top of the wheel arch, use the same point each side then adjust untill they are both the same at the desired new hight but dont go up more than 25 mm as the ride will get to hard and you could end up riding on the bump stops ;)

deli hustler:
thanks for that i'll let the spanner man know

redneck:
If it's a Mk1 delica(L300) then the suspension is very similar to a Paj whereas the MK2 delica(L400) has the torsion bar attached to the other wishbone and also the chassis isn't as strong on the L400 around the suspension mounts (so i was told by a guy who has lifted a few Delis L300 and L400's) Be warned winding up the torsion bars can put stress on the chassis of an L400 resulting in cracks.
Look on here
http://www.mdocuk.co.uk/

Navigation

[0] Message Index

[*] Previous page