Vehicle & Technical > Defender

propshaft u.j's

(1/5) > >>

M19 ROO:
can someone tell me how hard it is to chage the 4 u.j's?

and a kinda how to?

thanks Ric  :P

extreme90:
yea easy
big hammer, strong sturdy vice, drift or old socket and circlip pliers
remove prop
remove the circlips
place yoke in vice,
get a old socket that will fit inside where you just removed circlip
and hit it like you never hit before until the other end is sticking rite out and do the same on the next one,
take out of vice and crip the old bearing cups in the vice to remove them
you should be able worm the uj out now,
after removing the uj remove the other 2 remaining bearing cups
the fitting new is the reverse of that  :lol:
hope it makes sense  :roll:
dan

Hangover:
Any old Haynes manual will tell you step by step,pick one up at the car boot for a couple of quid.

extreme90:
yea but haynes manuals are crap tho  :roll:
i only brought one for tourqe wrench settings and wireing diagrams
everything else in there is utter garbage  :lol:
danny

M19 ROO:
nice one cheers for that! just need to ge some lanny u.j.'s then i can start lol  :lol:

Navigation

[0] Message Index

[#] Next page