Pages: [1]   Go Down

AuthorTopic: bloody cold in here  (Read 4846 times)

0 Members and 1 Guest are viewing this topic.

Offline RR Paul

  • Posts: 92
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
bloody cold in here
« on: October 19, 2004, 19:42:53 »
The pipes to the heater matrix have been bypassed, making me think that the matrix is knackered.
someone told me to "re connect it and chuck a load of radweld in it"
someone else told me " what ever ya do, do NOT use radweld!!!"
I'm confused now!
I can get a new matrix for £70, I think i'll go this route! apparently there are two sizes. Is there anyway of finding out the size without removing the complete dash??
F.Y.I I have a 93 LSE 4.2 (as it says below!)  :roll:
Logged

Offline MUSKIE

  • Posts: 232
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
bloody cold in here
« Reply #1 on: October 19, 2004, 20:46:27 »
from past experience the heater matrix is an absolute pig to change. yours might go easier though.
Logged

Offline Merlin

  • Posts: 271
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
bloody cold in here
« Reply #2 on: October 19, 2004, 21:02:47 »
Theres a good chance you can find one on "E" bay for a lot less than £70, loads of new stuff for Classics on there, dont know where it comes from--Cogs
Logged
1990 RR Vogue SE 3.9 EFI-Auto

Offline RR Paul

  • Posts: 92
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
bloody cold in here
« Reply #3 on: October 19, 2004, 21:15:49 »
I need to find out the size before i get one though  :(
Logged
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal